Directions
This digital lab represents a double pipe heat exchanger with countercurrent flow. It is designed to be used with this downloadable worksheet. Use the button at the top to start the pumps. Drag the valves on each inlet beaker to adjust flowrates. To measure temperatures, stop the pumps and press the "measure temperatures" button, then hover your mouse over each beaker to get the temperature and volume. Note that changing the flowrate valves while pumps are running will change the outlet temperatures, and thus reduce the accuracy of the observed temperature in the beakers, so it is important to adjust the valves before starting the pump.
Details

This simulation uses the NTU-effectiveness approach to calculate the outlet temperatures of each fluid line. Values were chosen to be realistic and similar to the values used in the actual experiment, and are randomized on each startup. A room temperature of 25°C was chosen, so water in the beakers will slowly equilibriate towards this value; you may notice this if you leave the simulation running for a very long time.

Additionally, the temperature measured in the outlet beakers are designed to show the average temperature of the outlet fluid and the heat capacity of the beaker initially at 25°C. Thus, for accurate results, it is recommended to let the heat exchanger flow for a long period of time, without changing any valves during the run.

About

This virtual lab was created in the Department of Chemical and Biological Engineering, at University of Colorado Boulder for LearnChemE.com by Drew Smith under the direction of Professor John L. Falconer and Michelle Medlin. This virtual lab was prepared with financial support from the National Science Foundation and is based on the Heat Exchanger experimental kit from Washington State University. Address any questions or comments to learncheme@gmail.com. Our simulations are open source, and are available on our LearnChemE Github repository. If this simulation is too big or too small for your screen, zoom out or in using command - or command + on Mac or ctrl - or ctrl + on Windows.

Reset Beakers
Reset beakers and pumps to gather new measurements. Select whether to re-randomize inlet temperatures as well:
Lab worksheet