1. Liquid flow rate.
×

Directions

In this simulation, a trayed stripping column is used to remove an impurity from a liquid feed by stripping the impurity into a gas stream. A stage is a plate that contacts the liquid solvent and the gas to promote mass transfer. Construct an x-y diagram step by step to determine the number of stages needed to achieve a certain separation. The operating line is obtained from a mass balance, and the phase equilibrium line is obtained from Henry's law. At any time, click the "new problem" button to generate a new set of conditions. Check "solution" to see the answer before clicking "next" to move on to the next step. Once you check "solution," you cannot change your answer. Once you click "next," you cannot go back to the previous steps. Check "hint" for help at any stage.

×

Details

The equilibrium line is calculated using Henry's law:

$y_{\mathrm{eq}} = \dfrac{H}{P}\,x,$
$H = H^0 \, e^{-\frac{E}{R}\left(\frac{1}{T}-\frac{1}{T_0}\right)},$

where $H$ is Henry's constant (atm), $P$ is pressure (atm), $H^0$ is Henry's constant at $T_0 = 298\,\mathrm{K}$ (atm), $R$ is the ideal gas constant (J/[mol K]), and $T$ is temperature (K).

The operating line is calculated from a mass balance around the stripper:

$x_0 L + y_{N+1} V = x_N L + y_1 V,$

which rearranges to:

$y_{N+1} = \dfrac{L}{V}\left(x_N - x_0\right) + y_1.$

The operating line is:

$y_{\mathrm{op}} = \dfrac{L}{V}x + \left(y_1 - \dfrac{L}{V}x_0\right),$

where $L$ is the liquid solvent molar flow rate (Mmol/h), $V$ is the vapor molar flow rate (Mmol/h), $x_0$ is the mole ratio of the impurity in the inlet liquid solvent stream (ppm), $y_{N+1}$ is the mole ratio of the impurity in the inlet vapor stream (ppm), $x_N$ is the mole ratio of the impurity in the outlet liquid solvent stream (ppm) and $y_1$ is the mole ratio of the impurity in the outlet vapor stream (ppm).

To count off stages, start at $x_0$ on the operating line ($x_0$, $y_1$) and draw a horizontal line to the equilibrium line ($x_1$, $y_1$). Then draw a vertical line down to the operating line. Repeat these steps until $x_N$ is reached.

The outlet liquid mole ratio $x_N$ is calculated from the mass balance:

$x_N = x_0 + \dfrac{y_{N+1} - y_1}{L/V}.$

Reference

[1] P. C. Wankat, Separation Process Engineering: Includes Mass Transfer Analysis, 3rd ed., Upper Saddle River, NJ: Prentice Hall, 2012.

×

About

This simulation was created in the Department of Chemical and Biological Engineering at University of Colorado Boulder for LearnChemE.com by John L. Falconer using Claude AI. It is a JavaScript/HTML5 implementation of a Mathematica simulation by Rachael L. Baumann. It was prepared with financial support from the National Science Foundation (DUE 2336987 and 2336988). Address any questions or comments to LearnChemE@gmail.com.

select the correct gas flow rate (Mmol/h)
⚠️ Simulation Under ReviewThis content is still being reviewed for quality and accuracy and may be updated in the future. Feel free to send us feedback.